flexiblefullpage - default
Currently Reading

Building Garages That Are Airtight

Advertisement
billboard - default
Quality Matters

Building Garages That Are Airtight

Garages are a difficult area to correctly detail, but also one of the most important


By Richard Baker July 19, 2017
how to seal a garage so it's airtight
This article first appeared in the August 2017 issue of Pro Builder.

Builders know that good air sealing makes a home more comfortable and energy efficient, but with an attached garage, it also serves an important health function. That’s because a poorly sealed wall or ceiling between the garage and the main house can let harmful fumes into the living space. These include carbon monoxide from vehicles and natural-draft gas water heaters, as well as VOCs from paints, solvents, and even the lawn mower’s gas can.

But while the International Energy Conservation Code requires air sealing between the garage and the conditioned space, this is an area where we continue to see problems, even when the rest of the house is done right. The problem is that the job of air sealing this space can be more complicated than with other parts of the building enclosure. For one thing, the wall separating the garage and living space will most likely be covered on both sides with drywall, which includes switches and outlets that are often poorly sealed. Another commonly overlooked area is where joists cross the wall between the conditioned space and the garage. Lack of blocking in each joist bay, accompanied by insufficient air sealing, can seriously compromise the air barrier.

Some builders make an airtight separation wall by installing the garage-side drywall, then insulating from the house side with spray polyurethane foam insulation. Others install a motion-sensing exhaust fan in the garage, which can continuously run at low speed and then kick into high when a vehicle or person enters the space. If someone opens the door, the negative pressure created by the fan will ensure that air flows from the house to the garage rather than vice versa. But beware that a fan may not be appropriate for a garage that contains an atmospherically vented water heater, as it could cause back-drafting.

Air Sealing Checklist for Garages

If adding continuous spray polyurethane foam or mechanical ventilation isn’t part of your solution, the following checklist will help ensure that the garage has been properly air sealed and that crews have addressed potential weak spots. The list assumes a garage with conditioned living space above and next to it.

• Make sure the door from the garage to the house has quality weather stripping and self-closing hinges. Apply three thick beads of sealant beneath the threshold.

• Where joists cross the wall between the conditioned space and the garage, install blocking in each joist bay and seal around the blocking with caulk or expanding foam. Acceptable blocking materials include plywood, OSB, and rigid insulation board.

• If the garage shares a slab with the home, use a pliable gasket to seal between the sill plate and the slab on the separation wall.

• Before installing the drywall, use expanding foam to fill gaps around any wire and plumbing penetrations in the wall or ceiling.

• When hanging drywall, use construction adhesive to seal around the edges.

• The water heater platform is a common source of air leaks. Make sure you install and seal the drywall in that area before building the platform.

• Install foam gaskets behind outlets and switch plates, and seal the boxes to the drywall with sealant for extra protection.

• Keep ductwork out of the garage. Even a small leak could draw harmful fumes into the living space. 

 

Richard Baker is program manager of the Builder Solutions Team at IBACOS.

Related Stories

Business Management

Walk on By? If You're Ignoring Waste, It's at Your Own Expense

Sure, there are new methods and tech advances that might save you some coin, but don’t overlook the big dollars right in front of you right now

Builder of the Year

Van Metre, Our 2022 Builder of the Year, Is Wired for Change

A deeply ingrained entrepreneurial spirit keeps Van Metre ahead of the curve and in control of its future

National Housing Quality Award

Apply NOW for the National Housing Quality Award!

Applying for the housing industry’s top business award will help your company improve profitability, achieve better customer satisfaction, and sell more homes

Advertisement
boombox1 -
Advertisement
native1 - default
halfpage2 -

More in Category




Advertisement
native2 - default
Advertisement
halfpage1 -

Create an account

By creating an account, you agree to Pro Builder's terms of service and privacy policy.


Daily Feed Newsletter

Get Pro Builder in your inbox

Each day, Pro Builder's editors assemble the latest breaking industry news, hottest trends, and most relevant research, delivered to your inbox.

Save the stories you care about

Lorem ipsum dolor sit amet lorem ipsum dolor sit amet lorem ipsum dolor sit amet.

The bookmark icon allows you to save any story to your account to read it later
Tap it once to save, and tap it again to unsave

It looks like you’re using an ad-blocker!

Pro Builder is an advertisting supported site and we noticed you have ad-blocking enabled in your browser. There are two ways you can keep reading:

Disable your ad-blocker
Disable now
Subscribe to Pro Builder
Subscribe
Already a member? Sign in
Become a Member

Subscribe to Pro Builder for unlimited access

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua.